Table of Contents
Advertisement
3
INSTALLATION AND CONNECTIONS
Connecting SENSOR ALARM OUT
terminals
The sensor alarm output terminals are used to relay alarm
signals whenever one of the digital video recorder's motion
sensors is triggered. Normally in an open condition, a
terminal adopts low condition when a sensor for the
corresponding camera number has been triggered.
1K
Rating for each terminal
Maximum current: 25 mA
Maximum voltage: 25 V
Connecting control terminals
The connections for a remote control circuit are shown
below. This digital video recorder can be remotely controlled
when a remote-control circuit similar to that shown here is
connected to the remote-input control terminals.
C
R1
R2
* Bundle the cables and wrap them
once around the core clamp before
attaching them.
R1
(When operated
(When combined
independently)
with R2 Shift key)
: Camera 1*: Not used
SW 1
: Camera 2*: Not used
SW 2
: Camera 3*: Not used
SW 3
: Camera 4*: SEQUENCE
SW 4
: Camera 5*: MON2
SW 5
: Camera 6*: OSD
SW 6
: Not used: QUAD
SW 7
: Not used: MULTI
SW 8
: Not used: MENU RESET
SW 9
: Not used: Not used
SW 10
: Not used: Not used
SW 11
: Not used: Not used
SW 12
: Not used: Not used
SW 13
: Not used: Not used
SW 14
: Not used: Not used
SW 15
: Not used: Not used
SW 16
Use a resistance of 1/10 ohms or more and with a D
ranking (Precision within ±0.5%).
The remote control cable should be no more than 5m
long.
1
There is no power switch. The display indicators flash, and
after a few moments, the monitor screen displays the
camera image.
R2
SW 17
: REC/STOP
: PLAY/STOP
SW 18
: STILL
SW 19
: SEARCH
SW 20
: SHIFT (Doubles with R1)
SW 21
: PLAY
SW 22
: REC
SW 23
: MENU
SW 24
: EXIT
SW 25
: +
SW 26
: -
SW 27
: →
SW 28
: ←
SW 29
SW 30
: ZOOM
: COPY
SW 31
: TIMER
SW 32
12
Connecting the power cord
When you have finished making all the
other connections, make sure the
voltage is 120V-240V AC and insert the
power plug into the wall outlet.
When turning the power ON for the first time
"PLEASE SET THE CLOCK" is displayed on the
monitor screen. Follow the procedures on P.15 to set
the clock.
If the clock is already set
The operation display area is displayed.
Operation
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
display area
If the POWER indicator starts flashing;
The POWER indicator flashes when there is a problem
with the hard disk. In this type of situation, initialize the
hard disk. ( P.83)
If you need to save video stored on the disk, contact the
dealer from whom you purchased this digital video
recorder.
The power cord's ground terminal is not provided for
enhanced safety; rather, it can be used to reduce the
level of interference when the digital video recorder is
connected to analog devices.
If a large amount of noise is generated when the digital
video recorder is connected to analog devices, connect
this terminal to the building's earth.
120V-240V AC
(50/60 Hz)
0
02
English
Advertisement
Table of Contents
