Operation; Connecting Sensor Alarm Out Terminals; Connecting Control Terminals; Connecting The Power Cord - Sanyo DSR-3506 Instruction Manual

3 INSTALLATION AND CONNECTIONS
Connecting SENSOR ALARM OUT
terminals
The sensor alarm output terminals are used to relay alarm
signals whenever one of the digital video recorder's motion
sensors is triggered. Normally in an open condition, a
terminal adopts low condition when a sensor for the
corresponding camera number has been triggered.
1K

Connecting control terminals

The connections for a remote control circuit are shown
below. This digital video recorder can be remotely controlled
when a remote-control circuit similar to that shown here is
connected to the remote-input control terminals.
C R1 R2
R1
(When operated
independently)
: Camera 1*: Not used
SW 1
: Camera 2*: Not used
SW 2
: Camera 3*: Not used
SW 3
: Camera 4*: SEQUENCE
SW 4
: Camera 5*: MON2
SW 5
SW 6 : Camera 6*: OSD
: Not used: QUAD
SW 7
: Not used: MULTI
SW 8
: Not used: MENU RESET
SW 9
SW 10 : Not used: Not used
SW 11 : Not used: Not used
: Not used: Not used
SW 12
: Not used: Not used
SW 13
SW 14 : Not used: Not used
SW 15 : Not used: Not used
: Not used: Not used
SW 16
Use a resistance of 1/10 ohms or more and with a D
ranking (Precision within ±0.5%).
The remote control cable should be no more than 5m
long.
English
Rating for each terminal
Maximum current: 25 mA
Maximum voltage: 25 V
R2
(When combined
with R2 Shift key)
SW 17 : REC/STOP
SW 18 : PLAY/STOP
SW 19 : STILL
: SEARCH
SW 20
SW 21 : SHIFT (Doubles with R1)
SW 22 : PLAY
SW 23 : REC
: MENU
SW 24
SW 25 : EXIT
SW 26 : +
SW 27 : -
: →
SW 28
: ←
SW 29
SW 30 : ZOOM
SW 31 : COPY
SW 32
: TIMER

Connecting the power cord

1
When you have finished making all the
other connections, make sure the
voltage is 120V-240V AC and insert the
power plug into the wall outlet.
There is no power switch. The display indicators flash, and
after a few moments, the monitor screen displays the
camera image.
When turning the power ON for the first time
"PLEASE SET THE CLOCK" is displayed on the
monitor screen. Follow the procedures on P.14 to set
the clock.
If the clock is already set
The operation display area is displayed.

Operation

display area
If the POWER indicator starts flashing;
The POWER indicator flashes when there is a problem
with the hard disk. In this type of situation, initialize the
hard disk. ( P.81)
If you need to save video stored on the disk, contact the
dealer from whom you purchased this digital video
recorder.
The power cord's ground terminal is not provided for
enhanced safety; rather, it can be used to reduce the
level of interference when the digital video recorder is
connected to analog devices.
If a large amount of noise is generated when the digital
video recorder is connected to analog devices, connect
this terminal to the building's earth.
11
120V-240V AC
(50/60 Hz)
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02