Table of Contents
Advertisement
2
INITIAL SET
8
Turn the jog dial to set T2 (minutes) to
"30" (minutes), and then turn the shuttle
dial clockwise.
"00:" from T3 flashes (indicating the hour).
Repeat steps 4 through 7 to make hour and minute
settings for T3 and T4.
9
In the same manner as described set
the hours and minutes of T1, T2, T3, and
T4 for "TIME PERIOD B" settings.
For both TIME PERIOD A and TIME PERIOD B, all
settings are "00:00" by default.
Settings for T1 through T4 cannot be made in such a
way that they extend over two days (i.e., include
midnight). If "00:00" (midnight) must be set, this should
be done using T1.
Any setting of "00:00" for T2 through T4 will be skipped.
Example:
T1
T2
06:00
12:00
In the above example, T4 (00:00) is skipped and T3
operates between 18:00 and 06:00.
Furthermore, when T1 through T4 are all set to "00:00",
all but T1 are ignored, and T1 operates from midnight to
midnight.
Time period operations settings
Example 2: Setting time period operation as follows.
Automatic selection and monitor masking for "TIME
PERIOD A".
Motion sensing for "TIME PERIOD B".
T3
T4
18:00
00:00
54
1
Turn the jog dial to move the cursor to
"SEQUENCE" within "SELECT TIME
PERIOD", and then turn the shuttle dial
clockwise.
"TIME PERIOD A" flashes.
2
Turn the jog dial to select "TIME
PERIOD A" or "TIME PERIOD B", and
then turn the shuttle dial clockwise.
The cursor moves to "MASK".
3
Set the time period for "MASK" and
"MOTION SENSOR" in the same way.
4
Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
Automatic selection, masking, and motion sensors are all
set to "TIME PERIOD A" by default.
EXIT
As a result of the above operations, "SEQUENCE" are
updated using main monitor and monitor 2 settings on
; "MASK" are updated using mask settings from on
P.92
; and "MOTION SENSOR" are updated using
P.94
motion sensor settings on
.
P.74
English
Advertisement
Table of Contents
