Deleting Transmitter Codes - Automatic Technology GDO-6v3 EasyRoller Installation Instructions Manual

Roll up garage door opener
Hide thumbs Also See for GDO-6v3 EasyRoller:
Table of Contents

Advertisement

Deleting Transmitter Codes

Step 13.1 - Deleting a Stored Transmitter
Code
a.
Select the transmitter you want to delete.
Press and hold the DOOR CODE BUTTON (Fig.
b.
27).
c.
Press the transmitter button you would like to
delete for two seconds, pause for two seconds,
press again for two seconds and then release.
d.
Release the DOOR CODE BUTTON. The code
should now be deleted. Confi rm this by pressing
the transmitter button - the function (e.g. door
opening) should not respond.
Step 13.2 - Deleting All Transmitter Codes
a.
1. Turn off power to the opener.
b.
While switched off, press and hold the DOOR
CODE BUTTON (Fig. 26). Turn on power to the
opener while holding this button.
c.
The OPEN LIMIT, CLOSE LIMIT and DOOR
STATUS LEDs will illuminate for about fi ve
seconds.
These LED's will turn off and the
CODING LED will illuminate.
d.
Release the DOOR CODE BUTTON. All stored
codes will now be deleted. Confi rm this pressing
buttons on any previously coded transmitters -
the opener should not respond.
Owner Installation Instructions
GDO-6v3 EasyRoller
fi g
26
®
21

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GDO-6v3 EasyRoller and is the answer not in the manual?

Table of Contents

Save PDF