The Optional Spa Side Switch; About The Led; Using Light Dimming From The Spa Side Switch; Using The Heater Bump Feature - Jandy AquaLink RS Owner's Manual

The optional Spa Side Switch is a four button remote unit that duplicates the functions of four buttons of your choice from the indoor
AquaLink RS Controller. To set which functions the Spa Side Switch will control, please see page 9. To use the Switch, simply press the
buttons. If the Switch is not operating, it may be locked out from the indoor control panel. See page 9 for details.
When the LED in the center of the Spa Side Switch is on, it indicates that water is circulating to the spa (for pool and spa models). When
the LED is flashing quickly, it indicates that the spa is heating. When it flashes slowly, it indicates that the heater is in cool down mode.
To dim a light from the Spa Side Switch, you must first assign a dimmable light to one of the Switch buttons.
From the Spa Side Switch, light dimming operates as follows:
When a button assigned to a light dimming auxiliary is pressed, the light will turn on at full brightness, and each press of the
button will decrease brightness 25%, until light is off.
The HEATER BUMP feature allows you to increase the temperature setting of the spa temporarily from the Spa Side Switch. If the spa has
reached your spa temperature setting and you still want to raise the temperature, use HEATER BUMP to raise the temperature one degree
at a time.
To use the HEATER BUMP feature, you must first assign the spa heater to one of the Spa Side Switch buttons.
Press the heater button on the Spa Side Switch twice in rapid succession to raise the spa temperature setting one degree. Each time you
press the heater button twice in this manner, the temperature setting will be raised an additional degree, up to a maximum spa temperature
of 104ºF. When the heater is turned off, the thermostat will reset to the original setting.
NOTE: Optional TWO SPEED RELAY required.
• For Pool and Spa Combination Units:
If your control is a POOL and SPA combination with a 2-speed filtration pump, the control will operate as follows: HIGH SPEED (Filter
Pump) must be on before LOW SPEED. Filter Pump button, as well as the Spa button, turns it to HIGH SPEED. LOW SPEED (AUX 2)
button toggles back and forth from LOW to HIGH.
• For Pool or Spa Only Units:
To use HIGH/LOW Speeds, FIlter Pump turns on HIGH SPEED, AUX 2 turns on LOW SPEED. Whatever mode last used is the off
button. To toggle, press whichever speed is not on.
• For Dual Equipment Units:
AquaLink RS 2/6 operates the same as the POOL/SPA Only units; i.e., Filter Pump turns on HIGH SPEED and AUX 2 turns on LOW
SPEED. The mode last used is the off button. To toggle, press whichever speed is not on. 2-speed works only on spa filter pump.
• Two Speed Programming for All Units:
When programming HIGH and LOW Speeds to operate together, think of HIGH SPEED (Filter Pump) as total duration of filtration time.
Then set LOW SPEED (AUX 2) to operate within that duration (e.g., if you want HIGH SPEED on for 2 hours and LOW SPEED for
10 hours, program the Filter Pump (HIGH SPEED) from 8 a.m. to 8 p.m. and LOW SPEED from 10 a.m. to 8 p.m. Also note: it is not
necessary to program both HIGH and LOW SPEEDS, even with a Combo Control System. If only LOW SPEED is programmed, HIGH
SPEED will turn on at the LOW SPEED on time to prime the pump. After 3 minutes the system will switch to LOW SPEED for the
remainder of its programmed time.