How To Set Freeze Protection; How To Activate Air Temperature Display; How To Change The Temp Readout - Jandy AquaLink RS Owner's Manual

The FREEZE PROTECTION Menu lets you assign freeze
protection to your pool and spa equipment. When a piece of
equipment is assigned to freeze protection, it will turn on when the
AquaLink RS detects freezing conditions. The main filter pump is
freeze-protected as a default.
You can change the temperature at which freeze protection will
activate (between 34ºF and 42ºF). For example, if you don't want
freeze-protected equipment to turn on until the air temperature has
dropped to 37ºF, you can set the system so this is the case.
Default freeze protection activation temperature is 38º F. Normal
items to assign to freeze protection are spa jet pump or waterfall
pump.
SPECIAL NOTE ON FREEZE PROTECTION: Freeze protection is intended to protect equipment and plumbing for short
periods of freezing only. It does this by activating the filtration pump and circulating water so that it won't freeze inside of
equipment or plumbing. Freeze Protection does not guarantee that equipment will not be damaged by extended periods of
freezing temperatures. In these conditions, the pool and spa should be shut down completely (i.e., drained of water and closed
for the winter) until warmer weather exists.
CAUTION: Activating the spa during freezing conditions will override freeze protection. This means that if you are using your
spa when freezing conditions exist, freeze protection will not circulate water to non-spa related equipment that you may have
freeze protected (e.g., pool cleaner, booster pump) and the potential exists for equipment damage.
The AIR TEMPERATURE Menu lets you turn the display of the air
temperature on and off on the AquaLink RS display. You must have
an air temperature sensor installed for this feature to operate.
NOTE: If an air temperature sensor is not installed, the Display will
read AIR TEMP SENSOR NOT INSTALLED if you try to activate this
item.
The DEGREES F/C Menu allows you to change the AquaLink RS
temperature display from Fahrenheit to Celsius or vice versa.
1. Press the MENU button, then press the FORWARD button and
scroll through until you reach SYSTEM SETUP. Hit ENTER and
then FORWARD to FRZ PROTECT. Hit ENTER again. The display
will read ASSIGN ITEMS <—>* .
2. Use the FORWARD and BACK arrow buttons to move between
ASSIGN ITEMS and TEMP SETTING. If you want to assign items
to freeze protection, press ENTER when ASSIGN ITEMS is
displayed. If you want to set the temperature at which freeze
protected items are activated, press ENTER when TEMP SET is
displayed.
3. If you are assigning items , the AquaLink RS display will read
ENTER DEVICE TO ADD TO FREEZE PROTECTION. Press
ENTER when done. Press the button of the equipment you want to
add to freeze protection.
4. If you are setting the temperature at which freeze protected
equipment is activated , use the FORWARD and BACK arrows to
change the temperature. Press ENTER when the desired
temperature is displayed.
1. Press the MENU button, then press the FORWARD button and
scroll through until you reach SYSTEM SETUP. Hit ENTER and
then Forward to AIR TEMP. Hit ENTER again. The AquaLink RS
display will read AIR TEMP ON <—>* or AIR TEMP OFF <—>*.
2. Use the FORWARD and BACK arrow buttons to toggle between
on and off. When the option you want is displayed, press
ENTER.
1. Press the MENU button, then press the FORWARD button and
scroll through until you reach SYSTEM SETUP. Hit ENTER then
FORWARD to DEGREES F/C Menu and press ENTER. The
AquaLink RS display will read FAHRENHEIT <- ->* .
2. Use the FORWARD and BACK buttons to toggle between
Fahrenheit and Celsius. When the option you want is displayed,
press ENTER.