How To Adjust The Temperature Display; How To Set The Assign Jva Buttons; How To Operate Dimmable Lights - Jandy AquaLink RS Owner's Manual

The TEMPERATURE CALIBRATION Menu allows you to "adjust"
the temperature that is displayed on the AquaLink RS Control
system by a few degrees so that it matches other water
temperature thermometers you may have.
NOTE: The Electronic Sensor is very accurate. Ensure that your
other thermometer is reading reliably before recalibrating. If the
temperature is off by more than four degrees, contact Jandy as to
the possible cause.
The ASSIGN JVA Menu lets you assign Jandy Valve Actuators
(JVAs) to any auxiliary button. This means that whenever you press
that auxiliary button, a valve turns. On pool/spa combination models,
there are two JVAs that can be assigned to auxiliary buttons: the
Cleaner JVA and the Solar JVA. On pool/spa only models, there are
four (4) JVAs available. The AquaLink RS installer must set up these
JVAs for this feature to operate correctly. Assigning JVAs lets the
owner control certain features like diverting water to a waterfall or
bank of spa jets.
The SET DIMMER Menu is used to assign auxiliary buttons to
control a dimmable light. Please note that your installer must
install a Light Dimming Relay in order for your light(s) to be
dimmable.
NOTE: An optional Light Dimming Relay must be installed and
only 110 VAC lighting can be dimmed.
Note: Be sure water temp sensor is properly connected while using this
procedure.
1. Press the MENU button, then press the FORWARD button and
scroll through until you reach SYSTEM SETUP. Hit ENTER then
FORWARD to TEMP CAL and press ENTER again. The AquaLink
RS display will give you a message to press ENTER to calibrate
temperature.
2. Use the FORWARD and BACK buttons to bump the temperature
display up or down. NOTE: This will not change the temperature of
the water, only the display of the temperature on the AquaLink RS
Display. Press ENTER when the desired temperature is displayed.
1. Press the MENU button, then press the FORWARD button
and scroll through until you reach SYSTEM SETUP. Hit
ENTER then FORWARD to ASSIGN JVA. Hit ENTER again.
The AquaLink RS display will read CLEANER JVA <—>*. If
both JVAs are being used, you will not be able to use this
menu.
2. Use the FORWARD and BACK arrows to toggle between
CLEANER JVA and SOLAR JVA. When the JVA you want to
assign to an auxiliary is displayed, press ENTER.
3. The AquaLink RS display will read SELECT AUX TO ASSIGN
JVA TO. Press the button of the Auxiliary that you want to
activate the JVA.
1. Press the MENU button, then press the FORWARD button and
scroll through until you reach SYSTEM SETUP. Press ENTER and
then FORWARD to SET DIMMERS <—>*. The AquaLink RS
display will read SELECT AN AUX TO OPERATE AS A DIMMER.
2. Press the AUX button you want to operate as a dimmable light and
press ENTER.
3. Dimmers can be set at 25%, 50%, 75% or 100%, depending upon
the amount of light desired, by pressing the AUX assigned as a
dimmer and using arrow (<—>*) buttons to dim or brighten. Once
desired brightness is achieved, press ENTER. Press AUX to turn
off. NOTE: When light is turned back on, it will automatically return
to the brightness last set.
4. From the Spa Side Switch, light dimming operates as follows:
When a button assigned to a light dimming auxiliary is pressed, the
light will turn on at full brightness, and each press of the button will
decrease brightness by 25%, until light is off.