Connecting Wires To Terminals - Kenwood KDC-W7037 Instruction Manual

Connecting Wires to Terminals

USB connector (1m)
(KDC-W7537U/W7537UY only)
To External Display/
Steering remote
Fuse (10A)
Wiring harness
(Accessory1)
External amplifier control wire (Pink/Black)
TEL mute wire (Brown)
Power control/Motor antenna
control wire (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
To USB device
FRONT
REAR
SUB
WOOFER
AUX input (Stereo)
Use the mini-plug which is stereo type and does not have
any resistance.
To Kenwood disc changer/External optional accessory
If no connections are made, do not
let the wire come out from the tab.
Battery wire (Yellow)
Ignition wire (Red)
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Do not remove the cap when you do not use the USB
cable. The connector will cause the unit to malfunction
if it gets in touch with any metallic part of the vehicle.
Front left output (White)
Front right output (Red)
Rear left output/Sub Woofer left output (White)
Rear right output/Sub Woofer right output (Red)
FM/AM antenna input
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
To connect these leads, refer to the relevant
instruction manuals.
To "EXT.AMP.CONT. " terminal of the amplifier
EXT.
having the external amp control function.
CONT
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal
P.CONT
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
ANT.CONT
Antenna Cord (ISO)
English
|
39