Connecting Wires To Terminals - Kenwood KDC-6011 Instruction Manual

Connecting Wires to Terminals
KENWOOD disc changer control input
| Fuse
To connect the Disc changer,
I Disc ch 1,
FM/AM antenna input consult your Disc changer manua
If no connections are made, do not let the wire come out from the tab.
Wiring harness
When using the optional power amplifier,
connect to its power control terminal.
pcontout|
Power control wire (Blue/White)
Power control/Motor antenna
: + control wire (Blue/White)
! (KDC-6011/5011 only)
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power termina! for the
booster amplifier of the film-type antenna.
Motor antenna control wire (Blue)
(KDC-6011/5011 only)
To car light control switch
Dimmer control wire (Orange / White)
(KDC-601 1/5011 only}
Ignition key
switch
Ignition wire (Red)
Car fuse — — 4 b
box Battery wire (Yellow)
(Main
fuse)
Ground wire (Black) O(To car chassis)
Battery
ACAUTION
AWARNING
If you connect the ignition wire (red) and the battery wire (yellow)
to the car chassis (ground), you may cause a short circuit, that in
turn may start a fire. Always connect those wires to the power
— A —
(Accessory@) "" YY
{ e
Rear left output (White)
Front left output (White)
White/Black
Gray/Black
FRONT © R
Green/Black
Purple/Black
i) To rear right
Purple
© To front left
speaker
White ®
© To front right
speaker
Gray
© To rear lett
speaker
Green
When only two speakers are being connected to the system,
connect the connectors either to both the front output terminals
or to both the rear output terminals (do not mix front and rear).
For example, if you connect the @ connector of the left speaker
to a front output terminal, do not connect the © connector to a