Connecting Wires To Terminals - Kenwood DPX-440 Instruction Manual

English
Connecting Wires to Terminals
FM/AM antenna input
== —->( En
Automatic ittumination/Dimmer |
4 Hi
control wire ornare
F ican |
Power control wire
( Blue/White) —
To car light control switch <=
When using the optional power
amplifier, connect to its power «
control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for <=
the booster amplifier of the film-type antenna.
Motor antenna control wire
{Blue}
ignition key -
switch Ignition wire (Red}
Car fuse ;
ies
ee
Battery wire (Yellow)
fisey Car fuse box
Ground wire (Black) G(To car chassis}
Battery
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
F
|
Front right output (Red)
sites Rear left output (White);
" Non-fading left output (White)
Rear
right output (Red)/
Non-fading right output (Red}
i Peers KENWOOD disc changer control input
To connect the Disc changer,
consult your Disc changer manual.
eat harness
(Accessory®)
qentGrBlaes
White
speaker
oreyiBlece
ots
"9 Hf] To front right
speaker
Green/Black
© To rear left
pom 6 HU speaker
To front left
Purple/Blage.
To rear right
> 2 ae 1 speaker
urple
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear}. For example, if you connect the & connector
of the left speaker to a front output terminal, do not connect
the © connector to a rear output terminal.