Built-In Auxiliary Input Setting; Power Off Timer; Cd Read Setting; Audio Preset Memory - Kenwood KDC-W7037 Instruction Manual

Menu system
In Standby mode

Built-in Auxiliary input Setting

Set the Built-in Auxiliary Input function.
Display Setting
"Built in AUX : OFF" When selecting the source there's no Auxiliary Input.
"Built in AUX : ON" When selecting the source there's Auxiliary Input.
In Standby mode

Power OFF Timer

Setting the timer to turn this unit's power OFF
automatically when Standby mode continues.
Using this setting can save the vehicle's battery
power.
Display Setting
"Power OFF : – – – –" Power OFF Timer function is OFF.
"Power OFF : 20min" Turns the power OFF after 20 minutes.
(Original setting)
"Power OFF : 40min" Turns the power OFF after 40 minutes.
"Power OFF : 60min" Turns the power OFF after 60 minutes.
In Standby mode

CD Read Setting

When there is a problem with playing a CD with
special format, this setting plays the CD by force.
Display Setting
"CD Read : 1" Play CD and Audio file.
"CD Read : 2" Play CD by force.
⁄
• Some music CDs may not play even in the "CD Read : 2"
mode.
|
34
English
Other than Standby mode

Audio Preset Memory

Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- <Audio Control> (page 8)
- <Audio Setup> (page 8)
2
Enter Menu mode
Using the Control knob, select "MENU".
For the operation method, refer to <Function
Control mode> (page 10).
"MENU" is displayed.
3
Select Audio Preset mode
Turn the Control knob.
Select the "Audio Preset" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Memory
Turn the Control knob.
Select the "Memory" display.
6
Determine whether to put the Audio Preset in
the memory
Press the Control knob.
"Memory?" is displayed.
7
Put the Audio Preset in the memory
Select "Yes" using the Control knob.
"Memory Completed" is displayed.
8
Exit Audio Preset mode
Press the [FNC] button.
⁄
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
• The following items cannot be registered.
Volume, Balance, Fader, Loudness, Volume offset, Dual
Zone System, Rear Volume