Connecting Wires To Terminals - Kenwood KDC-4009 Instruction Manual

Connecting Wires to Terminals
NOTE |! To connect the Disc changer, consult
your Disc changer manual.
KENWOOD disc changer control input
(KDC-4009 only)
FM/AM antenna input Nie
If no connections are
made, do not let the
wire come out from
the tab.
Connect either to the power contro! Power control/Motor antenna control wire
Front right output (Red)
(KDC-4009 only)
Rear right output (Red)
erminal when using the optiona
power amplifier, or to the antenna
-
To oe left
control terminal in the vehicle.
:
—(@ Speaker
b White
iti Wiring harness °
Ignition key
l
(Accessory())
LL
Gray/Black
Switch
'
© To front right
ac speaker
Ignition w i r e (Red) b Gray
nition wire (Re Oo
— g £! Green/Black
Gar incet
Car fuse box
3 r e (Yellow)
To rear left
ar TtuSe 00x attery wire enow Eo 3 speaker
(Main fuse}
= :
= Green ©
oi
Ground wire (Black) (To car chassis) @! Purple/Black
To rear right
Batter
w Speaker
'
oc
Purple ©
t
or
If you connect the ignition wire (red) and the battery wire (yellow)
to the car chassis (ground), you may cause a short circuit, that in
turn may start a fire. Always connect those wires to the power
source running through the fuse box.
OMe ar ee
ACAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output terminals
or to both the rear output terminals (do not mix front and rear}.
For exampie, if you connect the @ connector of the left speaker
to a front output terminal, do not connect the © connector to a
rear output terminal.