Connecting Wires To Terminals - Kenwood KDC-3047GY Instruction Manual

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo type
and does not have any resistance.
Front side
Wiring harness
Fuse (10A)
(Accessory1)
Steering remote control
(Light Blue/Yellow)
Mute control wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/ Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
A–7 Pin (Red)
A–4 Pin (Yellow)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
L
R
Rear output/ Sub Woofer output
(KDC-3047/KDC-3047M/KDC-3347/KDC-314 only)
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ANT.CONT
See next page.
Connector A
Connector B
Front output
(KDC-3247 only)
FM/AM antenna input (JASO)
To use the steering wheel remote control feature,
you need to an exclusive remote adapter (not
supplied) matches your car is required.
(KDC-3047/KDC-3047M/KDC-314 only)
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
17
|
English