Switching Preout; Built-In Amp Setting; Dual Zone System Setting; Supreme Setting - Kenwood KDC-W7037 Instruction Manual

Menu system
In Standby mode

Switching preout

Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound outputs
without being effected by fader control.)
Display Setting
"SWPRE : Rear" Rear preout.
"SWPRE : Sub-W" Subwoofer preout.
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON" The built-in amplifier activates.
"AMP : OFF" The built-in amplifier deactivates.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel sound
in the Dual Zone System.
Display Setting
"Zone 2 : Rear" Sub source (Auxiliary input source) is to be rear
channel.
"Zone 2 : Front" Sub source (Auxiliary input source) is to be front
channel.
|
30
English
In Audio file source

Supreme Setting

When AAC, MP3 or WMA files encoded at a low bit
rate (less than 96kbps (fs= 44.1k, 48kHz)) are played,
this function restores their high frequency region
to approach the sound quality of equivalents of
these files encoded at a high bit rate. Processing is
optimized for the compression format used (AAC,
MP3, or WMA), and adjustment is made for the bit
rate used.
Display Setting
"Supreme : ON" Plays sound using the Supreme function.
"Supreme : OFF" Plays the original sound stored in the audio file.
⁄
• The sound effect may be imperceptible depending
on the relationship between the audio file format and
setting.
• This function is not available on iPod.
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external amplifier
using the main unit.
Display Setting
"AMP Bass : Flat" Bass boost level is flat.
"AMP Bass : +6" Bass boost level is low (+6dB).
"AMP Bass : +12" Bass boost level is mid (+12dB).
"AMP Bass : +18" Bass boost level is high (+18dB).
⁄
• Refer to the catalog or instruction manual for power
amplifiers that can be controlled from this unit.
• For amplifiers, there are the models you can set from Flat
to +18 dB, and the models you can set from Flat to +12
dB.
When an amplifier that can only be set to +12 is
connected to the unit, "AMP Bass : +18" will not work
correctly even if it is selected.