Connecting Wires To Terminals - Kenwood DPX-4010 Instruction Manual

Connect ing Wires t o Term inals
FM /AM antenna input
To car light control sw itch
When using the optional pow er
amplifier, connect to its pow er
control terminal.
Depending on w hat antenna you are using,
connect either to the control terminal of the
motor antenna, or to the pow er terminal for
the booster amplifier of the film-type antenna.
Ignition key
sw itch
Car fuse
box
(M ain
Car fuse box
fuse)
Battery
+ –
2WA RN IN G
If you connect the ignition w ire (red) and the battery w ire
(yellow ) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Alw ays connect those
w ires to the pow er source running through the fuse box.
Fuse
(10A)
Automatic illumination/Dimmer
control w ire (Orange)
ILLUMI
Pow er control w ire
(Blue/White)
P.CONT
M otor antenna control w ire
(Blue)
ANT
CONT
ACC
Ignition w ire (Red)
ACC
Battery w ire (Yellow )
BATT
Ground w ire (Black) - (To car chassis)
— 30 —
M4×8mmMAX
FUSE 10A
KENWOOD disc changer control input
N OTE
To connect the Disc changer,
consult your Disc changer manual.
Wiring harness
(Accessory # )
White/Black
–
FRONT•L +
White
Gray/Black
–
+
FRONT•R
Gray
Green/Black
–
+
REAR•L
Green
Purple/Black
–
+
REAR•R
Purple
2CA U TION
When only tw o speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do not
mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
Front left output (White)
Front right output (Red)
Rear left output (White)/
Non-fading left output (White)
Rear right output (Red)/
Non-fading right output (Red)
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker