Direct Access Tuning; Station Preset Memory; Auto Memory Entry; Preset Tuning - Kenwood KDC-W7037 Instruction Manual

Tuner features
Function of remote control

Direct Access Tuning

Entering the frequency and tuning.
1
Select the band
Press the [FM] or [AM] button.
2
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
"– – – –" is displayed.
3
Enter the frequency
Press the number buttons on the remote
control.
Example:
Desired frequency
92.1 MHz (FM)
810 kHz (AM)
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• You can enter the FM band frequency in steps of a
minimum of 0.1 MHz.

Station Preset Memory

Putting a station in the memory.
1
Select the band
Push the Control knob towards [FM] or [AM].
2
Select the frequency to put in the memory
Push the Control knob towards [4] or [¢].
3
Enter Preset Memory mode
Using the Control knob, select "P.MEM".
For the operation method, refer to <Function
Control mode> (page 10).
4
Select the number to put in the memory
Turn the Control knob.
5
Determine the number to put in the memory
Press the Control knob.
6
Allow the determined number to take effect
Press the Control knob.
|
16
English
Press button
[0], [9], [2], [1]
[0], [8], [1], [0]
Cancelling the Preset Memory mode
Press the [FNC] button.
⁄
• This function can be operated with [1] — [6] button.
- Press the desired [1] — [6] button for at least 2 seconds.

Auto Memory Entry

Putting stations with good reception in the memory
automatically.
1
Select the band for Auto Memory Entry
Push the Control knob towards [FM] or [AM].
2
Open Auto Memory Entry
Press the [AME] button for at least 2 seconds.
When 6 stations that can be received are put in the
memory Auto Memory Entry closes.
⁄
• When the <AF (Alternative Frequency)> (page 32) is ON,
only RDS stations are put in the memory.
• When Auto Memory Entry is done in the FM2 band, the
RDS stations preset in the FM1 band are not put in the
memory.
Likewise, when Auto Memory Entry is done in the FM3
band, RDS stations preset in FM1 or FM2 are not put in
the memory.

Preset Tuning

Recalling the stations in the memory.
1
Select the band
Push the Control knob towards [FM] or [AM].
2
Enter Preset Tuning Select mode
Turn the Control knob.
3
Select a desired station in the memory
Turn the Control knob.
4
Recall the station
Press the Control knob.
Cancelling Preset Tuning
Press the [FNC] button.
⁄
• This function can be operated with [1] — [6] button.
- Press the desired [1] — [6] button.