Audio Preset Recall; Firmware Version Display; Demonstration Mode Setting - Kenwood KDC-W7037 Instruction Manual

Other than Standby mode

Audio Preset Recall

Recalling the sound setup registered by <Audio
Preset Memory> (page 34).
1
Select the source
Press the [SRC] button.
Refer to <Selecting the Source> (page 7).
2
Enter Menu mode
Using the Control knob, select "MENU".
For the operation method, refer to <Function
Control mode> (page 10).
"MENU" is displayed.
3
Select Audio Preset mode
Turn the Control knob.
Select the "Audio Preset" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Turn the Control knob.
Select the "Recall" display.
6
Determine whether to recall the Audio Preset
Press the Control knob.
"Recall?" is displayed.
7
Recall the Audio Preset
Select "Yes" using the Control knob.
"Recall Completed" is displayed.
8
Exit Audio Preset mode
Press the [FNC] button.
⁄
• The User memory of "SYSTEM Q" in <Audio Control>
(page 8) is changed to the value which was recalled.
• The source tone memory item of <Audio Control> (page
8) is changed to the value which was recalled by the
selected source.
Function of KDC-W7537U/KDC-W7537UY
In Standby mode

Firmware version display

Displaying the firmware version with the unit.
Turn the Control knob.
Select the "F/W Version : " display.
In Standby mode

Demonstration mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Turn the Control knob.
Select the "DEMO Mode" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO Mode : ON" The Demonstration mode function is ON.
"DEMO Mode : OFF" Exit Demonstration mode (Normal mode).
|
35
English