Removing An Expansion Card From Expansion-Card Riser 2 Or 3 - Dell PowerEdge R730 Owner's Manual

Card Card type
priority
12 Gb SAS (full height)
11 Integrated RAID
12 NDC

Removing an expansion card from expansion-card riser 2 or 3

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. When removing a card from Riser 3, ensure that the PCIe holder latch is closed.
NOTE: The procedure for installing and removing a full length PCIe card is similar to the procedure
for removing and installing a GPU card. For more information, see
Installing a GPU card.
Steps
1. Disconnect any cables connected to the expansion card.
2. Lift the expansion-card latch out of the slot.
3. Hold the expansion card by its edges, and remove it from the expansion-card connector.
4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot
opening and close the expansion-card latch.
5. Replace the expansion-card latch into the slot.
6. Close the expansion-card locking tabs.
NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
98
Slot priority
PowerEdge
R730
7, 6, 4, 5
integrated slot
integrated slot
Safety instructions.
Before working inside your
PowerEdge PowerEdge
R730xd R730
6, 4, 5 4
integrated slot 1
integrated slot 1
system.
Removing a GPU card
Max allowed
PowerEdge
R730xd
3
1
1
and