Removing The Vflash Media Unit - Dell PowerEdge R730 Owner's Manual

Figure 91. Removing and installing the SD vFlash media card
1. SD vFlash media card
3. To install an SD vFlash media card, with the label side facing up, insert the contact-pin end of the SD
vFlash media card into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4. Press the card inward to lock it into the slot.

Removing the vFlash media unit

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
NOTE: This procedure applies only to PowerEdge R730xd systems.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1. Remove the screw securing the vFlash media unit to the chassis.
2. Remove the cable from the vFlash media unit and the backplane.
3. Slide the vFlash media unit toward the front of chassis and lift it out of the system.
Safety instructions.
Before working inside your
2. SD vFlash media-card slot
system.
169