APPENDIX B: LCD SLIDING BRACKET
The LCD sliding bracket is preassembled on the right hand side, when facing the stove, but
can be installed on the opposite side. Lowering the mounting bracket will be necessary if the
hot air distribution kit is to be installed (see position #2).
Step 1
To reverse the assembly to a left side configuration, extend the rail with the LCD support (A)
in order to gain access to the two screws (B). Remove the screws, rotate the rail 180° and
reassemble the rail to the mounting bracket (C) using the screws previously removed.
Step 2
Remove the screws (D) located on the top edge of the back of the stove. Secure the
mounting bracket (C) in place with the same screws.
87
Euromax Pellet Stove Installation and Operation Manual