Effect Wheel - Martin MAC 2000 Performance User Manual

3 Remove the gobo retention spring from the gobo holder and drop the gobo out of the holder. Insert the new
gobo in the holder. Insert the spring with the narrow end against the gobo. To identify the narrow end, press
the spring flat: the narrow end is on the inside. Push the end of the spring in under the lip of the holder.
4 Work the rim of the gobo holder under both clips and snap the gobo holder back into position. If necessary,
a small screwdriver or similar tool may be used to pry the clips away from the wheel.
5 Replace the top cover and release the pan and/or tilt locks before operating.

Effect wheel

The effect wheel provides a variable frost filter and two positions for effects. The MAC 2000 Performance comes with
a wide angle lens and a nine-fact prism installed in these positions.
Wide angle lens
(beam expander)
Variable frost filter
To repl ace effects
1 Disconnect the fixture from power and allow it to cool.
2 Lock the head in the upside down position and remove the bottom cover. Turn the effect wheel so that the
locking plate is under the sensor bracket.
3 To remove, hold the rim of the effect holder and pull back on the locking plate. Remove effect from wheel.
4 To insert, pull back on the locking plate. If both effects are removed, pull straight back on both tabs. Position
the groove in the effect holder over the fixed plate. Release the locking plate and verify that the effect is
properly seated.
22
Coated side
MAC 2000 Performance
9-facet prism
Open position