Dual Network Usage; Global Usage - Motorola MC65 Manual

Dual Network Usage

The MC65 can be set up to be used on both a CDMA and GSM/UMTS networks and the user can switch between
them.
NOTE Each active network account uses its own phone number.
When an AT&T SIM card is installed in the MC65, the user interface for the CDMA settings is hidden. To
restore access to these settings, please contact Motorola Enterprise Mobility Support.
Obtain an active GSM/UMTS SIM card.
1.
Activate the MC65 on a CMDA network. See
2.
Install the SIM card. See
3.
To set the MC65 to use the CDMA network:
Tap > Start > Setting > Connections > Phone network Setup.
1.
On the Band tab, tap Network type and select CDMA First or CMDA Only.
2.
Tap OK.
3.
To set the MC65 to use the GSM/UMTS network:
Tap > Start > Setting > Connections > Phone network Setup.
1.
On the Band tab, tap Network type and select GSM/UMTS First.
2.
On the GSM/UMTS tab, tap the Update Connection Settings button.
3.
Tap OK.
4.

Global Usage

CDMA networks can be used internationally will the use of a Global SIM card provided by the CDMA carrier. After
arriving, install the global SIM card into the MC65. See
To set the MC65 to use the global SIM card:
Tap > Start > Setting > Connections > Phone network Setup.
1.
On the Band tab, tap Network type and select GSM/UMTS First.
2.
Tap GSM/UMTS Preferred and select Auto (GSM & UMTS), GSM Only or UMTS Only.
3.
Tap Band and select All, NA & CA, EMEA/APAC or Brazil.
4.
On the GSM/UMTS tab, tap the Update Connection Settings button.
5.
NOTE If using an unsupported network, data connection and MMS settings must be manually configured. See
Configuring a GSM Data Connection on page 5-5
information.
Tap OK.
6.
Upon return, remove the global SIM card.
7.
CDMA Network Setup on page
Installing the SIM Card on page
Installing the SIM Card on page
5-1.
1-3.
and refer to the MC65 User Guide for MMS set up
Phone Setup 5 - 3
1-3.