Table of Contents
Advertisement
10. Help
10 Help
10.1 Error messages – Reports
If a problem occurs during fax transmission or reception, one of the following messages will be printed on the
confirmation and journal reports (page 32).
Message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
JUNK FAX PROH. REJECT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPONDING
PRESSED THE STOP KEY
OK
56
Code
Cause & Solution
40-42
L A transmission or reception error occurred. Try
46-72
again or check with the other party.
FF
43
L A line problem occurred. Connect the telephone line
44
cord to a different jack and try again.
L An overseas transmission error occurred. Try using
the overseas mode (feature #23 on page 49).
-----
L Remove the jammed document (page 66).
53
L A transmission or reception error occurred because
54
of a problem with the other party's fax machine.
59
Check with the other party.
70
-----
L The junk fax prohibitor feature of this unit rejected
fax reception.
-----
L The memory is full of received documents due to a
lack of recording paper, a lack of ink film or a
recording paper jam. Install paper (page 13), install
ink film (page 11) or remove the jammed paper
(page 65).
-----
L The document was not fed into the unit properly. Re-
insert the document and try again.
-----
L The other party's fax machine is busy or has run out
of recording paper. Try again.
L The other party's fax machine rang too many times.
Send the fax manually (page 32).
L The other party's machine is not a fax machine.
Check with the other party.
L The number you dialed is not in service.
-----
L {STOP} was pressed, and fax transmission or
reception was cancelled.
-----
L Fax transmission or reception was successful.
Advertisement
Table of Contents
