Rollers; Cleaning/Replacing The Print Roller; Cleaning The Drawing Roller - Avery Dennison AP7.t User Manual

06/05 Rev. 3.03-01

Rollers

Cleaning/replacing the print
roller
Contamination on the print roller can
degrade the print quality and the transport
of the material.
Clean the printhead [20A] and the print
roller [20C] regularly, and always clean
them before inserting a new ribbon. When
using direct thermal mode, always clean
them before inserting a new material roll.
Cleaning the printhead: See Section
Cleaning the printhead with a cleaning pen
on page 6.
How to clean/replace the print roller:
1. Switch off the printer.
2. Remove the label material and ribbon from
the printer.
3. Remove thumb screw [20B].
4. Pull out the print roller [21A].
5. Sprinkle roller cleaner onto a lint-free cloth
and wipe the roller with it. Gradually rotate
the roller until it is completely clean.

Cleaning the drawing roller

1. Release the pressure roller.
2. If installed: Disassemble the tear-off edge
[22C]. This makes it easier to get at the
drawing roller. (Tool: Torx screwdriver
size 10).
3. Sprinkle solvent onto a lint-free cloth and
wipe the drawing roller [22B] with it. Grad-
ually rotate the roller until it is completely
clean.
4. Refit the tear-off edge.
USER MANUAL
AP 7.t
A
B
[20] A Printhead
B Thumb screw
C Print roller
[21] Pulling out the print roller (A)
C
[22] A Pressure roller
B Drawing roller
C Tear-off edge
Maintenance & Cleaning
C
A
A
B
12