Cleaning The Printhead; Cleaning The Platen Roller And Printer - Avery Dennison Monarch 9416 XL Equipment Manual

C l e a n i n g t h e P r i n t h e a d
Clean the printhead whenever you notice a decline in print quality, or after using three
rolls of supply.
Note: You must turn off the printer's power before you clean the printhead. If you
need to clean the printhead during a print job, you may lose your data when
you turn off the printer.
1. Turn off the printer. Press the switch on the
back of the printer to the OFF position (O).
2. Press the release levers towards the front of
the printer to release the supply door.
3. Lift open the supply door. A supply door
support at the right-hand rear of the printer
holds the supply door open.
4. Moisten a cotton swab with isopropyl alcohol.
Rub the cotton swab across the printhead to
5.
remove any build-up.
6. Allow the printhead to dry for one minute
before you close the supply door and resume
printing.
C l e a n i n g t h e P l a t e n R o l l e r a n d P r i n t e r
Moisten a cotton swab with isopropyl alcohol and run the cotton swab across the
platen roller. Turn the platen roller with your finger and make sure it is clean all
the way around.
Note: Do Not remove the platen roller.
♦
Slightly dampen a cloth with water and wipe the exterior surfaces clean.
♦ Use a dry, soft-bristled brush to clean paper dust out of the interior.
4-2 Equipment Manual
Platen Roller