Cleaning - Avery Dennison ADTP2 Operator's Handbook Manual

C l e a n i n g
Clean the printhead, peel bar, sensor, and platen roller:
when there is any adhesive build-up in
♦
the supply path.
after printing approximate ly three rolls
♦
of thermal transfer/ther ma l direct
supplies or after each ribbon.
daily if your printer is in an excessively
♦
dirty, hot, or humid environmen t.
if there are voids or streaking in the
♦
print as shown.
V oi ds
1. T urn off the printer, open the cover and printhead
assembly.
2. Remove the supply roll and ribbon.
3. Press down on the exit cover tabs to open the exit
cover on the front of the printer.
4. Spray the supply path and sensor with compresse d
air to remove dust and debris.
5. Use a cotton swab moistened with isopropyl alcohol
to clean the printhead, peel bar, peel roller, sensor,
and platen roller when you see significant adhesive
build-up or after clearing a jammed label.
Note : Use a printhead CLEAN ST RIP (120350) if the
printhead is extremel y dirty
or you see streaks on the supply.
6. T urn the platen roller and peel
roller with your finger to make
sure it is clean all the way
around.
Caution: Do not use solvent-
based cleaners
containing naptha or
petroleum distillates on
the platen roller. Only
use isopropyl alcohol or
mild soap and water.
5-2 Operator's Handbook
S tre a ks