Connector Fixed By Bolts; Area Used; Connection Of The Connector - Toyota Automobile Electrical Repair And Modification

B–52
TERMINAL AND CONNECTOR REPAIR–HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS
Connector B
Lass than 1mm
Cross–section of the bolt
68
1.
2.
Connector A
3.
Connector B
Connector A
Bolt
Wire Harness Repair Manual (RM1022E)

Connector fixed by bolts

Area used

D Engine control computer harness
Cut the connection of the connector.
(1) Remove the connector A.
(2) Loose the bolt using a tool like driver until the
connector B can be removed by hand and separate
the connector.
HINT: If the bolt can not be removed, roll it while pulling
forward.

Connection of the connector

(1) Temporarily fit the connector B.
(2) Tighten the bolt by using tool like driver and fit the
connector B completely.
NOTICE:
D Tighten the bolt until feeling it lighter. Then confirm
that the width of chink of the connector B is less
than 1mm.
D The bolt can be rolled after it is fitted.
D If the impact wrench is used, do not let it rolling
more than three seconds. (The housing may be
deformed by generated heat)
D Be sure and connect the connector B straight. Do
not incline it while connecting.
(3) Connect the connector A.