How To Install And Remove Special Connectors; Low Fit And Lever Type Connector; Cut The Connection Of The Connector; Connect The Connector - Toyota Automobile Electrical Repair And Modification

TERMINAL AND CONNECTOR REPAIR–HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS

HOW TO INSTALL AND REMOVE SPECIAL CONNECTORS

Lever
1.
2.
Lever
Wire Harness Repair Manual (RM1022E)

Low Fit and Lever Type Connector

[Case 1]

Cut the connection of the connector

(1) Push the place indicated by the arrow.
(2) The lock is released and lever is lifted up.
(3) Lift the lever up until it stops.
(4) Cut the connection of the connector.
NOTICE:
Do not hold the wire harness to pull it.

Connect the connector

(1) Connect the connector in the condition that the lever
is fully lifted up.
HINT: If the lever is locked at the lower position, follow
the procedure [Case 1]. (1) to (3) and lift the lever up fully.
B–47
63