TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Lock Housing
Upper Housing
Upper Housing Attached Lock Housing
Lower
Housing
Insulation Displacement Connector (0.64 Type)
(a)
NOTICE:
D Securely Lock it.
D Be careful not to mistake the upper housing and
lower housing when putting together.
(b)
NOTICE:
D Afteruniting, securely lock it for not leaving the rear
lock arm deformed.
D Make sure that the terminals will not become loose
by pulling the wires lightily.
D Be careful not to mistake the upper housing and
lower housing when putting together.
3.
When properly installed, pulling gently on the
wire lead will prove the terminal is locked in the
connector.
Wire
Pull
Wire Harness Repair Manual (RM1022E)
Install the upper housing to the lock housing.
Make the projection of the front lock of the upper
housing attached lock housing meet the ditch of the
front lock of the lower housing and fix the rear lock.
B–45
61