Toyota Automobile Electrical Repair And Modification page 39

TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Special Tool
Raise Up
Special Tool
Terminal Retainer
[Retainer at Full Lock Position]
Terminal
Retainer
[Retainer at Temporary Lock Position]
Type K (For Insulation Displacement Connector)
(1)
Special Tool
Using a special tool, release the lock and separate the
connector into 2.
NOTICE:
Do not apply too muck force to the lock arm.
Lock
(2)
Cover
Using a special tool, release the lock and open the cover.
NOTICE:
Do not apply too much force to the lock arm.
Special Tool
Type L (For 0.64 Type Connector)
Special Tool
Insert Mark
(1)
HINT:
the connector's shape (number of terminals, etc.), so
check the position before inserting it.
Terminal
Retainer
Stopper
Wire Harness Repair Manual (RM1022E)
Separate Connector
w/ Cover : Open Connector Cover
Using the special tool, raise the retainer up to the
temporary lock position.
The needle insertion position varies according to
B–21
37