Double Locking Type Connector - Toyota Automobile Electrical Repair And Modification

B–38
TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Terminal Retainer
Example:
Good
Bad
∗ Terminal
In Short
Position [Female]
[Male]
54
2.
Double Locking
Device
Good
Bad
∗ Terminal
In Short
Position
Wire Harness Repair Manual (RM1022E)

Double Locking Type Connector

(with terminal retainer or double locking device)
The connector is fitted with a terminal retainer, or a double
locking device, it is in the temporary lock position at insert
the terminal.
Type A (For 0.64III, 1.0, 1.0II, 1.3, 1.8, 2.3II 4.8 and 8.0 of
Non–Waterproof Type Connector)
(a) Insert the terminal.
HINT:
1. Make sure the terminal is positioned correctly.
2. Insert the terminal with terminal retainer in the
temporary lock position.
(b) Insert the terminal until the locking clip locks firmly.
HINT:
1. Pull the terminal back gently to check whether it is
locked correctly.
2. If it cannot be inserted easily, check the terminal and
the connector for damage.
NOTE: If the terminal to locking clip does not lock firmly,
the double locking device cannot lock or terminal retainer
does not lock at full lock position so the terminal backs out
from connector.
(c) Close terminal retainer or double locking device.
The connector is fitted with a terminal retainer, or a
double locking device, return it to the full lock position.