Error Messages - Kyocera FS-1020MFP Operation Manual

Error Messages

If a problem has occurred in the machine, you will be notified by the following display.
• The Attention indicator on the operation panel is lit or flashing.
• An error code appears in the display on the operation panel.
• KYOCERA Client Tool and Status Monitor will show the status of the machine.
If the Attention indicator is lit or flashing and an error code appears in the display on the operation panel, check the
KYOCERA Client Tool or Status Monitor.
Error code E-0001
This is displayed in repeating
two-digit segments (E-, 00, and 01).
Note If the indicators light or flash repeatedly in manners not described above, a service error has probably
occurred. Switch off the power switch, unplug the power cord, and then plug the power cord back in and switch on
the power switch. This may clear the error. Even if the error is not cleared, contact your service representative.
Problems that can be resolved by the user are described below.
Message displayed in
Error Code KYOCERA Client Tool
and Status Monitor*
C-F040
Error has occurred
C-####
Error has occurred
(except C-F040)
E-0001
Non-genuine toner is
installed
E-0002
Error has occurred
E-0003
Memory full
E-0004
Error has occurred
E-0007
Add toner
Meaning
An error has occurred in the
machine.
An error has occurred in the
machine.
The installed toner container is
non-genuine.
The installed toner container's
regional specification does not
match the machine's.
Scanning cannot be performed due
to insufficient memory of scanner.
The number of scanned pages
exceeds the maximum number.
The toner has run out.
7-7
Remedy
Turn the power OFF and then ON.
Make a note of the error code displayed
on the operation panel, and contact your
service representative.
The manufacturer assumes no
responsibility for damage caused by a
non-genuine toner.
We recommend that you only use
genuine toner containers.
When you want to use the toner
container currently installed, press the
Mode Select key and [Stop/Reset]
simultaneously for 3 seconds or more.
Install the specified toner container.
Only the scanned pages are available.
Press [Stop/Reset] and the job will be
canceled.
The maximum number of scanned
original pages is 99. Only the scanned
pages are available. Press [Stop/Reset]
and the job will be canceled.
Replace with a new toner container.
Troubleshooting