Handset Installation, Scenario 1 (Recommended); Handset Installation, Scenario 2 - ASCOM d41 DECT Configuration Manual

Configuration Manual
Ascom d41 DECT Handset
3.2.1

Handset installation, Scenario 1 (Recommended)

Note: If the handset shall be subscribed towards an IP-DECT system, the IP-DECT software
version must be 3.1.X or higher. If that is not the case, use Scenario 2.
Note: The handset to be installed must not have any previous valid registrations. If it has a
valid registration, unsubscribe the handset or use Scenario 2.
Subscribe and create an identity
1 Assign an extension number in the DECT system for the handset. See the
corresponding manual for the DECT system.
2 Subscribe the handset towards the DECT system. The subscription procedure is
described in User Manual, Ascom d41 DECT Handset, TD 92582GB.
During the subscription procedure, the Number in PDM/IMS2 will automatically be
set to be the same as the extension number.
Note: The User ID can be viewed by navigating to the menu:
Admin menu > Device info > User ID
To find the Admin menu, see
See also examples of handset configurations that can be made in chapter
Configuration
3.2.2

Handset installation, Scenario 2

Create an identity
Note: The handset may not have a User ID. If a User ID exists, it can be removed by
performing a facory reset, see
.def file for the handset has been imported to the PDM/IMS2.
1 Insert the handset in a desktop charger or rack charger connected to PDM/IMS2.
2 In PDM/IMS2, navigate to the "Devices" tab and locate the handset in the list of
devices. The handset is identified by finding the IPDI of the handset in the Device ID
column.
3 Select the handset, make a right-click, select "Assign number..." and preferably
enter the extension number for the handset.
The number that is assigned must not be present under the "Numbers" tab. If this
is the case, it is recommended to delete the number before "Assign number..." is
performed.
The User ID can be viewed in the handset by navigating to the menu:
Admin menu > Device info > User ID
See also examples of handset configurations that can be made in chapter
Configuration
Subscribe the handset
1 Assign an extension number in the DECT system for the handset. See the
corresponding manual for the DECT system.
2010-01-28/ Ver. D
6.1 Admin Menu Tree
on page 15.
4.5 Perform a Factory reset
on page 15.
on page 22.
5 Handset
on page 10. In addition, a valid
5 Handset
TD 92641GB
6