ASCOM d41 DECT Configuration Manual page 28

Configuration Manual
Ascom d41 DECT Handset
SERVICE NEEDED
Invalid IPDI
Note: This display message is
only shown in English.
Enter PIN code
Battery low, charge now
Phonebook is not available at
the moment.
Voice mail number not
defined
Could not encrypt
connection
License key not accepted
2010-01-28/ Ver. D
Easy replacement procedure
not followed correctly or
failure during easy
replacement procedure.
Phone lock is activated.
The battery level is low.
The phonebook is not
activated or does not
respond.
There is no Voice mail
number defined in the
handset.
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base
station(s); and/or,
2) Unsupported base
station(s).
1)The license key is to short/
long
2) The license key is not valid.
TD 92641GB
Send the handset for service.
Enter the required PIN code.
If the PIN code has been lost,
enter a new PIN code via the
PDM/IMS2 or do a factory
reset via the PDM/IMS2.
Charge the handset, or
replace battery.
Try again later or if the fault
persists do a factory reset via
the admin menu or via the
PDM/IMS2.
Note that it may take several
minutes for the phonebook
to be available if there are
many entries in Contacts
and/or company phonebook.
Define a Voice mail number
via the PDM/IMS2.
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in
the base station(s); and/or,
Note: If Ascom's base
station(s) is used, the
software version must be
3.1.x or greater.
3) Use supported base
station(s). Ask your supplier.
1)Make sure that the license
key consists of 29 digits.
2) Generate a valid license
using the License Web.
25