Handset Replacement With Win-Pdm, Scenario 1; Handset Replacement With Win-Pdm, Scenario 2; Brazil Or Other Latin America Countries - Dect Frequency Configuration - ASCOM d41 DECT Configuration Manual

Configuration Manual
Ascom d41 DECT Handset
If the handset is not saved, insert it into a desktop charger or rack charger connected to
the PDM and perform a save.
Note: If it would be impossible to save the old handset settings, stop this replacement
procedure. Instead register the new handset and follow the instructions for installing a
handset, see
The following steps are described in two different scenarios, check which one suits the
best before proceeding.
4.8.1

Handset replacement with Win-PDM, Scenario 1

Subscribe the new handset with the same extension number as the old handset. During
the subscription procedure the PDM identity (User ID) will automatically be set to be the
same as the extension number.
Note: The User ID can be viewed by navigating to the menu Admin menu > Device info >
User ID.
1 Insert the new handset into a desktop charger or rack charger connected to the
PDM.
2 A pop-up dialogue appears, asking the user to decide whether to use the Number
settings in PDM or the Number settings in the device. Select PDM.
The handset will automatically be synchronized and all data and parameter settings
will be transferred to the new handset. The synchronization will take a while if the
Contacts in the original handset contains a large number of contacts.
Note: If subscribing towards an IP-DECT system, the IP-DECT software version must be
3.1.X or higher. If not, use Scenario 2.
Note: The handset to be installed must not have any previous valid registrations.
Unsubscribe handset or use Scenario 2.
4.8.2

Handset replacement with Win-PDM, Scenario 2

1 Insert the new handset into a desktop charger or rack charger connected to the
PDM.
2 A pop-up will be displayed. Select the option "Associate with number". Follow the
instructions and select the number of the old handset, see Installation and
Operation Manual, Portable Device Manager (PDM), Windows Version,
TD 92325GB.
The handset will automatically be synchronized and all data and parameter settings
will be transferred to the new handset. The synchronization will take a while if the
Contacts in the original handset contains a large number of contacts.
3 Subscribe the new handset.
4.9 Brazil or other Latin America countries – DECT frequency configuration
Note: This chapter is only applicable if the handset is used in Brazil or other Latin
American countries.
In order to change the operating frequency band, the following preconditions must be
fulfilled:
2010-01-28/ Ver. D
3.2 Installation of a new Handset on page 5.
TD 92641GB
13