Driver Installations - Icom id- rp4000v Instruction Manual

D Microsoft ® Windows Vista
Manual un-installation from each unit and connector
is needed when using Microsoft
In this section, describes the un-installation instruc-
tion with the ID-RP4000V [SERVICE T] for example.
®
® Windows Vista
Click
Click
Click
Click
® .
q Start up Windows.
w Connect the PC and the ID-RP4000V [SERVICE T]
connector through a USB cable.
e Open the "Device Manager" screen.
• See "n COM port confirmation (p 24)" to open the
"Device Manager" with Microsoft
r Click "
Right click the "ICOM ID-RP4000V SERVICE T
(COMQ)" , then select "Uninstall".
t Click to add the check mark, "4," into "Delete the
driver software for this device." then click [OK].
y Right click the "ICOM ID-RP4000V SERVICEQ" ,
then select "Uninstall".
u Click to add the check mark, "4," into "Delete the
driver software for this device." then click [OK].
NOTE: Un-install the USB drivers for ID-RP4000V
[SERVICE R] with the same manner.
26 26
DRIVER INSTALLATION
®
Windows Vista
" of Ports (COM&LPT).
4
®
.