When Install Into System Rack; Rubber Feet Attachment; Grounding; Rubber Feet - Icom id- rp4000v Instruction Manual

n When install into system rack
n Rubber feet attachment
q
w
n Grounding
• Cross section
CONNECTIONS AND INSTALLATIONS
The ID-RP4000V is designed to install into a standard
EIA 19-inch rack.
Use the supplied bolts with the rack when fixing the
ID-RP4000V.
We recommend to use the rack that has rails be-
cause the weigh of the ID-RP4000V is approx. 7.5 kg
.
(16.5 lbs)
Attach the supplied rubber feet onto the bottom of the
ID-RP4000V as shown at left when you do not install
the ID-RP4000V in the 19-inch rack. Desktop opera-
tion can be performed.
To prevent electrical shock, television interference
, broadcast interference
(TVI)
lems, ground the transceiver through the GROUND
terminal on the rear panel.
For best results, connect a heavy gauge wire or strap
to a long earth-sunk copper rod.
Make the distance between the [GND] terminal and
ground as short as possible.
R WARNING! NEVER
minal to a gas or electric pipe, since the connec-
tion could cause an explosion or electric shock.
4 4
3
and other prob-
(BCI)
connect the [GND] ter-