Error Codes And Messages; User Status And Customer Attendance Messages - Lexmark C540n Service Manual

Error codes and messages

User status and customer attendance messages

User primary
message
Busy
Calibrating
Close door
Check Config ID
Check Model Name
Check Serial Num
<color> Low
Defragmenting Flash
DO NOT POWER
OFF
Flushing buffer
Formatting Flash
DO NOT POWER
OFF
Hex Trace
Imaging Kit
Insert Tray <x>
Invalid Engine Code
Invalid Network Code
Load <source> with
<custom string>
Load <source>
<custom type>
Load <source>
<type or size>
Explanation
Wait for the message to clear.
The printer is performing a color adjustment. Wait for the message to clear.
Message clears when front cover, right cover, and toner door are closed or securely
fastened.
The printer configuration ID is invalid.
Message clears when a valid model name is set.
Message clears when a valid serial number is set.
Replace the toner cartridge, and then wait for the message to clear.
The printer is performing the defragmentation operation of flash memory. Wait for the
message to clear.
Warning: Do not turn the printer off while this message appears on the display.
Wait for the message to clear.
Wait for the message to appear.
Warning: Do not turn the printer off while this message appears on the display.
This message appears between status messages and warnings. Wait for the
message to clear.
Replace the imaging kit, and then press Select (
continue printing.
This message is displayed when the printer requests the user to insert tray x before it
can continue printing the job. The printer needs to pick media from the missing tray or
the trays below it.
Tray x=Tray 1, Tray 2, Tray 3.
Note: This message displays when refilling the trays during a job. Before filling a tray,
take the printer offline by pressing Stop (
the output bin.
The following actions can be taken:
• Insert the requested tray.
• Press Stop ( ), and then press to cancel printing.
The engine code is invalid.
The Network code is invalid.
Printer does not detect media meeting the description <custom string> in <source>,
where <source> is Tray 1, Tray 2, Tray 3, or multipurpose feeder.
• Load the input source with the correct type and size media.
• Press Stop ( ), and then press Select (
Printer does not detect media meeting the description <custom type> in <source>,
where <source> is Tray 1, Tray 2, Tray 3, or Multi-Page
feeder.
• Load the input source with the correct type and size media.
• Press Stop ( ), and then press Select (
Printer does not detect media meeting the size requested in the source indicated.
• Load the input source with the correct type and size media.
• Press Stop ( ), and then press Select (
5025-2xx, 4xx
) to clear the message and
), and wait for pages to stop feeding into
) to cancel printing.
) to cancel printing.
) to cancel printing.
Diagnostic information
Previous
Next
Go Back
2-5