Lexmark C540n Service Manual page 51

Service error messages (1xx, 9xx) (continued)
Error code Description
109.02 Service The black printhead failed to complete
Black Printhead servo.
109.03 Service The black printhead mirror motors
Black Printhead failed to achieve lock.
109.04 Service The black printhead mirror motors lost
Black Printhead motor lock.
109.05 Service Failure reading NVRAM from
Black Printhead printhead.
109.08 Service The black laser showed bad in testing.
Black Printhead
109.11 Service Failure writing data tot he printhead.
Black Printhead
109.12 Service Failure reading data from the
Black Printhead printhead.
109.13 Service Printhead declared error.
Black Printhead
122.xx Service Fuser error
Fuser Error
122.01 Service Attempting to print with estimated
Fuser Error power at or below minimum power.
122.02 Service Fuser over temperature.
Fuser Error
122.03 Service Fuser open thermistor check failed.
Fuser Error
122.04 Service Attempting to print with estimated
Fuser Error power at or above minimum power.
122.05 Service Fuser failed to reach final temperature
Fuser Error in time.
122.06 Service Attempting to print when the estimated
Fuser Error power is too low.
122.07 Service Timed out waiting for home sensor
Fuser Error event.
Action
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-52.
Go to
"Fuser service check" on
page 2-31.
Go to
"Fuser service check" on
page 2-31.
Note: Some of these errors are caused by
a faulty component on the LVPS. Check
the history file in the printer to verify other
occurences. If there are others, replace the
LVPS. Go to
"Low-voltage power supply
(LVPS) assembly removal" on
page 4-51.
Go to
"Fuser service check" on
page 2-31.
Go to
"Fuser service check" on
page 2-31.
Go to
"90x.xx error (902.xx–907.xx)" on
page 2-24.
Go to
"90x.xx error (902.xx–907.xx)" on
page 2-24.
Go to
"90x.xx error (902.xx–907.xx)" on
page 2-24.
Go to
"Fuser service check" on
page 2-31.
Diagnostic information
5025-2xx, 4xx
Previous
Next
Go Back
2-15