Print Quality-Solid Color Page; Print Quality-Vertical Banding - Lexmark C540n Service Manual

Print quality—solid color page
Service tip: A solid color page is generally caused by a problem in the high-voltage
controller or an incorrect high-voltage in the printing process resulting in toner
development on the entire photoconductor drum.
Step Questions / actions
Replace the photoconductor unit (part of the
1
imaging unit). Remove the imaging unit and
remove the developers. Place the original
developers in the new photoconductor, and
then replace the imaging unit. See
unit (IU) removal".
Does this fix the problem?
A faulty printhead can cause the problem. To
2
test the printhead for solid colors, place a
narrow strip of paper over the gap between the
developers. Make sure the paper stays in
place when you replace the imaging unit. This
will block the laser from discharging the
photoconductors. Print a Quality Test Page.
Does the page have a white vertical band?
Check the high-voltage contact from the HVPS
3
to the photoconductor charge roll. Ensure the
contact springs are properly mounted and that
the charge roll contact spring is making good
contact with the HPVS spring that runs through
the left printer frame. See
contacts" on page 4-71
mounting and for removal procedures.
Are the spring(s) defective?
Turn the printer off, and check the continuity of
4
the HVPS cable.
Is there continuity?
Replace the HVPS. See
5
supply (HVPS) assembly removal" on
page 4-38.
Did this solve the problem?
Print quality—vertical banding
Replace the developer unit.
Problem resolved.
"Imaging
Replace the printhead. See
"Printhead removal" on
page
Replace the transfer contact
assembly. See
cartridge contacts" on
page
"Toner cartridge
to view the proper
Go to step 5.
Problem resolved.
"High-voltage power
Yes
Go to step 2.
Go to step 3.
4-69.
Go to step 4.
"Toner
4-71.
Replace the cable
assembly.
Replace the controller
board. See
board removal" on
page
Diagnostic information
5025-2xx, 4xx
Previous
Go Back
No
"Controller
4-20.
2-51
Next