8.18 SCSI Bus Width
When using the SCSI-connected scanner, you can select a data transfer width.
Configure the settings for the SCSI Bus Width as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select [Device Setting 2] from left side list in the window, and select [SCSI
Bus Width] from its lower level.
3.
Select either 16-bit or 8-bit.
ATTENTION
170.
To use SCSI cards and/or SCSI cables that do not support Ultra Wide SCSI,
select "8-bit".
8.18 SCSI Bus Width
8
199