Imprinter Selection - Fujitsu FI-5900C Operator's Manual

8.22 Imprinter Selection

You can specify which imprinter to use; Pre-imprinter or Post-imprinter, if you already have installed these
options.
Configure the settings for the Imprinter Selection as follows:
1. Start up the Software Operation Panel.
Refer to "8.1 Scanner Settings" on page
2. Select [Device Setting 2] from left side list in the window, and select
[Imprinter selection] from its lower level.
3. Select the Imprinter to use.
Normal (obey Host specification): Complies with the scanner driver setting.
Forcibly select Pre-imprinter:
Forcibly select Post-imprinter:
HINT
170.
Pre-imprinter is forcibly used to print unless directed by
the scanner driver.
Post-imprinter is forcibly used to print unless directed by
the scanner driver.
For details on the specifications of the imprinter, refer to
page 205.
"9 OPTIONS" on

8.22 Imprinter Selection

8
203