Operator Panel - Fujitsu FI-5900C Operator's Manual

1.2 Operator panel

The operator panel is located on the right side of the scanner. The panel consists of a Function Number
Display, buttons and LEDs.
Name
Function Number dis-
play and Function button
Function
Hopper height
adjustment button
Hopper Height
Document thickness
adjustment button
Paper Thickness
Thin Thick
[Send to] button
Send to
[Scan] button
Scan
Power button
Function number display
Shows the status of the scanner.
For details, refer to "Indications on the Function Number Display" (page
Use these buttons to adjust the height of the Hopper to the Upper/Middle/
Lower Positions.
The hopper moves automatically to the right position after recieving a scan-
ning command. However, this may cause a delay before the actual scanning
starts. To avoid unnecessary waiting time, it is recommended to set the hop-
per height prior to scanning. For details, refer to
Height" on page 15.
Use this buttons, to set the paper thickness of the documents.
(Normally no need to change from the default setting)
For details, refer to "2.9 Setting the Paper Thickness" on page
Use this button to start linked application.
(* About the settings, refer to section
button" on page 64, or the FUJITSU TWAIN32 scanner driver
Use this button to turn the power ON/OFF.
When the power is turned on, the button is illuminated in blue.
Function
Hopper Height
Paper Thicknes s
Thin Thick
Send to Scan
.
Function
"2.5 Setting the Hopper
"2.14 Before Using [Scan] / [Send to]
1.2 Operator panel
1
6).
29.
help.
5