Installing The Software; Bundled Software; Setting The Scsi Id - Fujitsu fi-5530c2 Getting Started

The SCSI ID initially set at the factory is [5].
HINT If the SCSI ID of another SCSI device is set
to the same ID, either change the scanner's
SCSI ID or SCSI ID of the other SCSI
device. For details on how to change the
SCSI ID, refer to "Setting the SCSI ID" in
this section.

■ Setting the SCSI ID

The factory initial setting for SCSI ID is [5].
1. Press the power button at least for two sec-
onds to turn off the scanner. Disconnect the
AC cable from the outlet.
2. Set the SCSI ID using the SCSI ID switch on
the back of the scanner.
Click
ID No.
0 to 7 Can be set as the ID
Works with the factory default value
8, 9
(SCSI ID = 5).
3. Press the power button to turn on the scanner.
When the scanner is turned ON, the SCSI ID set
at step 2 is enabled.
Description

2.3 Installing the Software

■ Bundled Software

The following software are bundled with the scanner:
• PaperStream IP (TWAIN) Driver
Conforms to the TWAIN standard. Used when
you operate the scanner using TWAIN-compli-
ant applications.
• PaperStream IP (ISIS) Driver
Conforms to the ISIS standard. Used when you
operate the scanner using ISIS-compliant appli-
cations.
• 2D Barcode for PaperStream
This option can recognize two dimensional
codes.
Can be used with the PaperStream IP (TWAIN)
driver, the PaperStream IP (ISIS) driver, or
PaperStream Capture.
For details about the installation, refer to readme
in the 2D Barcode for PaperStream Setup CD-
ROM.
• Software Operation Panel
Configure various settings such as the operation
of the scanner and managing the consumables.
Installed together with the PaperStream IP
(TWAIN) driver and PaperStream IP (ISIS)
driver.
• Error Recovery Guide
Shows the error status and countermeasures
when an error occurs. Installed together with the
PaperStream IP (TWAIN) driver and Paper-
Stream IP (ISIS) driver.
• PaperStream Capture
An image scanning application that supports the
PaperStream IP (TWAIN) driver and Paper-
Stream IP (ISIS) driver. By defining scan set-
tings as document profiles, you can customize
the settings according to your preference.
• ScanSnap Manager for fi Series
An application that scans images with the driver
settings that are used exclusively for ScanSnap
Manager for fi Series. PaperStream IP (TWAIN)
driver is required to use this application. Enables
easy scanning with a single button.
You can download and install this application
from the download web page.
6