Setting A Roll Media - Ricoh L4160 Operation Manual

Setting a roll media

1
Move the roll holder located in the back of
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and then move it.
2
Check the clamp lever located in the back of the
device is lowered.
3
Move the roll holder to the roll setting position.
Roll Holder
Set Position
• There are two types of the internal diameter
of the roll media paper tube: 2 inch and 3
inch.
• Check the roll stopper is not caught between the roll stopper arm and this machine.
• When using a media of greater width, set this so that the media width
can be more inside than
• If a media is misaligned to the right/left more than fixed position, a
warning is displayed. Set the media again.
2-8
Set the base posi-
tion of roll holder
within this range.
3 Inch Roll Media
2 Inch Roll Media
.
Do not set
outside this
mark.
Roll holder
fixing screw
3 Inch Roll Media
Roll Holder
Set Position
2 Inch Roll Media
Setting position
of 2inch tube
Roll Holder Side
(The back of this machine)
E R ROR 5 1 6
ME D I A S E T P O S I T I ON R
E R ROR 5 1 6
ME D I A S E T P O S I T I ON L
Do not set
outside this
mark.
Roll holder
Roll holder
Basis
Setting position
of 3inch tube