Ricoh L4160 Operation Manual page 142

7
Press the
• Start pushing ink out.
• Flow ink in the jig by 10cm.
• Flow ink from all ports of the damper selected in the Step 3.
8
Terminate air purge by pressing the
• Close the port.
9
Press the
• The carriage returns to the cap position.
• Filling to the damper starts. Wait for a while until the amount of ink
returns to the normal status.
• When filling has been completed, cleaning is performed.
• When ink filling into the damper has been completed, the screen
returns to the one in the Step 2. For other dampers, perform the
procedures from the Step 3 to 8.
10
Press
5-8
key.
• When removing the jig, ink may leak. Put a
paper towel etc. around the port.
key.
the key several times to end the setting.
A I R PG
COMP L E T ED
Reference value :
About 10cm
key.
CA PP I NG POS I T I ON
MOVE S T AR T
P L E A SE WA I GT
* * C L EAN I NG * *
P L E A SE WA I GT
[ EN T ]
Ink
[ EN T ]