Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message
I N V A L I D O P E R A T I ON
CO V E R O P E N
I N V A L I D O P E R A T I ON
ME D I A U N D E T E C T E D
I N V A L I D O P E R A T I ON
MO T OR P OWE R O F F
I N V A L I D O P E R A T I ON
I N K E R ROR
I N V A L I D O P E R A T I ON
D A T A R EMA I N
Message displayed in LOCAL
Message
< L OC A L >
C a n' t P R I N T / C A R T . [ E N T ]
< L OC A L >
C h e c k w a s t e
i n k [ MN T ]
< L OC A L >
R e p l a c e W I P E R [ MN T ]
< L OC A L >
W I P E R C L E A N I NG [ MN T ]
< L OC A L >
* * NO ME D I A * *
< L OC A L >
D A T A R EMA I N
Cause
The front cover or the maintenance
cover is opened.
The media has not been detected.
The motor is OFF after the cover
was opened etc.
An ink error occurred.
Data was received.
Cause
Ink errors (unusable ink) occur in
multiple cartridges.
Ink supply (print, cleaning, etc.)
cannot be performed.
The waste ink bottle is nearly full.
Time to replace the wiper in the cap-
ping station with a new one has come.
(The wiping count has reached the
specified value.)
Time to clean the wiper in the capping
station with a new one has come.
(The wiping count has reached the
specified value.)
The media is not set.
The sensor has been broken.
The data has been received.
Solution
Check the front cover and maintenance
covers.
If the same error message appears again
even after closing all the covers, contact
your local distributor to call for service.
Perform media detection.
Close the front cover and maintenance
covers.
Check the Eco-cartridge for the supply
path corresponding to the indicated
color.
Perform data clear. (
P.2-29)
Solution
Press the
key to check the
Eco-cartridge generating the warning.
Replace them with usable cartridges.
Check the waste ink bottle.
Press the
key to correct or
MAINT.
reset the counter. (
P.4-29)
Press the
key and replace the
MAINT.
wiper with a new one.
(
P.4-28)
Press the
key and clean the
MAINT.
wiper. (
P.4-5)
Set the media. (
P.2-5) If the same
error message appears again, contact
your local distributor to call for service.
key to perform print-
Press the
ing.
Or, perform data clear.
1
1
1
1
5
5-11