Ricoh L4160 Operation Manual page 39

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow ....................................................... 2-2
Turning the Power ON/OFF .......................... 2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-4
Setting a Media ............................................. 2-5
Adjusting the Head Height .......................... 2-5
Note for media setting ................................. 2-7
Setting a roll media ..................................... 2-8
Take-up device .......................................... 2-13
Setting leaf media ..................................... 2-14
Changing the printing origin ...................... 2-16
Preparing for the Heaters ............................ 2-17
Changing the Temperature Settings for the
Heaters ...................................................... 2-17
Checking the Heater Temperature ............ 2-18
Changing the Temperature Settings for
the Drying Heater ...................................... 2-18
Test Feeding ............................................... 2-19
Test Printing ................................................ 2-20
Test Printing .............................................. 2-21
Head Cleaning ............................................ 2-22
About head cleaning ................................. 2-22
Basic Operations
Perform head cleaning depending on the
test printing result ......................................2-22
Set the media feeding .................................2-23
Setting Feed Correction .............................2-23
Correct the ink drop position for bidirectional
printing ........................................................2-25
Printing Data ...............................................2-27
Checking the Status of Ink Cartridges .......2-27
Checking the Status of Waste Ink Bottle ...2-27
Starting a Printing Operation .....................2-28
Stopping a printing operation halfway ........2-29
Deleting Received Data (Data Clear) ........2-29
Behavior after printing has been
completed ..................................................2-29
Cutting a media ..........................................2-30
When [NEAR END] error occurs while
printing .......................................................2-30
When [INK END] error occurs while
printing .......................................................2-30
When a waste ink bottle confirmation
message appears while printing ................2-31
Chapter 2