Correct the ink drop position for bidirectional printing
When the condition for printing (media thickness/head height/etc.) has been changed, perform the following
operation to correct the ink drop position for bidirectional (Bi) printing and obtain the proper printing result.
Example of a Drop Position correct Printed Pattern
• The correction pattern for aligning the ink drop position cannot be printed on a media whose width is
less than 450 mm. Print quality cannot be guaranteed in such a case. Use unidirectional printing.
Output
direction
1
Set a media on the machine and set a printing origin. (
2
Press the
3
Press the
4
Press
• Setting value: Y600dpi / Y900dpi / Y1200dpi
• Perform correction for all resolutions.
5
Press the
6
Press the
• Test pattern is printed. (The printed patterns are called Pattern 1,
Pattern 2, Pattern 3... in the order of printing.)
7
Press
1~.
• Corrected feeding rate: -40.0 to 40.0
• Open the front cover and check the test patterns. The position where an outward feeding line and a
return feeding line become one straight line is the correction value.
• When the correction value in not between -40.0 and 40.0, adjust the height of the printing heads and
then perform the operations in Step 2 and later.
key twice in LOCAL.
key.
to select the resolution.
key.
key to start pattern printing.
to correct the dot position of Pattern
The dots at the fourth position counted from the zero
position in the positive direction form a straight line.
In this case, the dot position correction value is 4.0.
P.2-5)
DROP . POS c o r r e c t
DROP . POS c o r r e c t
: Y 6 0 0 d p i
DROP . POS c o r r e c t
: Y 6 0 0 d p i
DROP . POS c o r r e c t
PR I N T
* * PR I N T I NG * *
P A T T ERN 1
=
[ EN T ]
[ EN T ]
P L E A SE WA I T
0 . 0
2-25
1
2
4
5
6