Preparing for the Heaters
Changing the Temperature Settings for the Heaters
Set the heater temperature.
Depending on the media and the profile to use, set the heater temperature.
• It may take several minutes to tens of minutes for the set temperature to be reached, depending on the ambient
temperature.
• You can change the temperature set here also in [HEATER] of the [SETUP] menu. (
1
Press the
2
Press the
3
Press
each heater.
Heater selecting
Temperature setting : Set with
• The heater starts to get hot.(The [HEAT] lamp lights in orange.)
• When the heater temperature reaches the set temperature, the [HEAT] lamp goes off and the
[CONSTANT] lamp lights in green.
4
Press the
• The screen moves to the temperature setting of FAN HEATER.
• The Heater temperature is controllable at the RIP side if the RIP in use has a function controllable.
(For the setting procedures, refer to the instruction manual of the RIP in use.)
• Depending on the power supply voltage, amount of heat generation differs. For the power supply
voltage of 100V to 120V, it may not reach 70 °C.
• If you set [VACUUM] of the [SETUP] menu more than needs, it may cause temperature decrease of
the print heater.
• Use this machine under 20 to 30°C. The temperature may not reach the set value due to the
environmental temperature condition.
• When you lower the heater temperature, ensure drying time with the procedures below:
• Set [SET UP] – [DRYING TIME].
• Increase the number of printing passes.
• Print unidirectionally.
key.
key.
to set the temperature of
: Select with
key to end the setting.
P.3-2)
PRE
PR T
POS T
2 3 ° C
2 3 ° C
2 3 ° C
Heater temperature
confirming display
The set temperature: 20 to 70°C
OF F
OF F
OF F
2 3 ° C
2 3 ° C
2 3 ° C )
(
OF F
OF F
OF F
2 3 ° C
2 3 ° C
2 3 ° C )
(
Current heater temperature
2-17
1
2
4
5
6